Listed at $499,800
Available for SaleBOAT HOUSE100' 1959 Other
Rare Opportunity
Prime Location Fresh Water kept Custom Built Boathouse & Drydock facility for vessel upto 100ft LOA x 22ft Beam. Refit in 2005. Boathouse permit included.
Key features include:
- Steel hull contruction
- Upgraded Bigtop Super Duty 22 ounce NFPA flame retardant PVC Vinyl top (2005)
- Klockner Moeller & Siemens circuit breakers features 100 amp & 50amp service for vessels plus additional breakers
- Westinghouse DT-3 Tansformer (3 Phase / 60Hz / 112.5kva)
- Ballast tanks with four controller pumps & Hytork 280 actuator valves to make raising and lowering drydock convenient
- 10 x Jim-Buoy Roller Bumpers for easy docking plus addtional 2 x Jim-Buoy 214 Giant Roller Fenders 14" Diameter x 44" Length at the boathouse entrance
26 North Yachts is pleased to assist you in the purchase of this vessel. This boat is centrally listed by Denison Yachting. It is offered as a convenience by this broker/dealer to its clients and is not intended to convey direct representation of a particular vessel
Specifications
| LOA: | 100' (31 m) |
| Beam: | 40' (13 m) |
| Hull Material: | Steel |
| Location: | SEATTLE, United States, Washington |
| Build Year: | 1959 |
| Builder: | Other |
| Model: | BOAT HOUSE |
| Type: | Other |
Details
Overview
Drydock structure is a 100’x42’ barge hull design, with (2) 3’x20’x82’ wing walls. The hull has one longitudinal bulkhead on centerline and three transverse bulkheads, for a total of 8 compartments. In 2005 it was modified and refit which included:
- Two longitudinal steel pontoon tanks (5’4” diameter) were welded to the existing structure
- To these were added fiberglass decking panels to create an internal walkway around the structure
- A 29’ high galvanized steel 2” arch truss structure was installed on the wing wall tops to carry a Bigtop Super Duty 22 ounce NFPA flame retardant PVC Vinyl top
- The trusses are set at approximately 10’ centers. There is an entrance door at the shoreward end
- The outside end is open for vessel entrance, with netting and drawstring to close
The vessel that was stored in there was 98ft long x 20ft beam.