Interested in this yacht? Contact Us

Available for SaleAbaco 4040' 2022 Bruckmann 

Designed by Mark Ellis, the Abaco 40 is a stylish but practical day cruiser, providing stability, an easy ride and fuel efficiency. A centerline skeg provides directional stability and tracking performance as well as grounding protection. 2022 models are being built on a limited series basis.

26 North Yachts is pleased to assist you in the purchase of this vessel. This boat is centrally listed by Worth Avenue Yachts. It is offered as a convenience by this broker/dealer to its clients and is not intended to convey direct representation of a particular vessel

Specifications

LOA: 40' (13 m)
Beam: 10' (4 m)
Hull Material: Fiberglass
Fuel Capacity: 300 gal (1,136 L)
Fresh Water Capacity: 80 gal (303 L)
Holding Tank: 30 gal (114 L)
Location: Newport, Rhode Island, United States
Build Year: 2022
Builder: Bruckmann
Model: Abaco 40
Type: Motor Yachts

Details

Overview

Conceived as a stylish but practical day cruiser with accommodation for occasional longer ventures, the Abaco 40 finds favor with those who want fine sea keeping and performance in a boat with classic aesthetics.

The hull configuration utilizes broad chine flats aft on a modified deep vee form that provides characteristic stability and an easy ride and motion. The Abaco 40 is powered by a single Cummins 670 HP diesel that cruises in low 20 knot range with a top speed of approximately 30 knots and a propeller and rudder protected by a skeg. Also available in twin engine pod drive form with a top speed in the high 30’s.

Accommodations are generous with ample galley space, storage, machinery access and cockpit.

The Abaco 40 is being build on a limited series basis.

Structure

•tFiberglass roving & unidirectional E-glass reinforced structural grid with limber holes providing longitudinal floors forming engine beds with transverse frames

Hull Construction

•tVinylester resin throughout

•tSingle piece vacuum bagged Core-Cell cored fiberglass molding

•tExtra reinforcing as required

•tCore removed in way of al thru-hulls, shaft log, rudder port & center line

•tFRP centerline prop protecting skeg for single engine installation

•tAwlgrip hull finish

Deck Construction

•tSingle piece foam cored fiberglass molding with non-skid pattern on all working surfaces

•tSand-textured non-skid surfaces finished in choice of color

•tCore phased out in way of all deck fittings

•tOverlapping hull/deck joint bonded and fastened every 4”

•tSwim platform with swim ladder

•tTransom door to platform

Mechanical

•tCummins 670 H.P. diesel engine with electronic display

•tDigital engine instrument panel for tach, oil pressure, fuel consumption etc.

•tDual density engine sound insulation

•tIsolated bilge area under engine

•tRaw water cooled exhaust with muffler

•t2” Aqua Met propeller shaft with zinc anode

•t(4) blade bronze propeller • Sidepower bow thruster

•tDripless shaft seal • Bronze rudder

•tDual engine room ventilation

•t(2) 150 US gallon vented fuel tanks with level indicator at helm

•tDual Racor fuel filters

•tRaw water intake with strainer

•tHydraulic steering

•tElectronic throttle shift control

•tBennett trim tabs

•tStainless steel steering wheel

Plumbing

•tPressure water with hot & cold faucets in head/shower and galley

•tCockpit shower

•tWater heater, 11 gallon, 110V & engine heat exchanger

•t(80) US gallon water tank with level indicator at helm

•tPolished stainless steel sinks in galley & head

•tSingle lever chromed brass faucets

•tRigid colour coded PVC plumbing

•tVacuflush head with 30 US gallon holding tank

•tHolding tank overboard discharge with 12 volt macerator

•tAll sea cocks Marelon

•t(2) 1500 gallon per hour bilge pumps with float switches

•tIntegrated manual bilge pump

Electrical

•tAll wiring sized & colour coded to ABYC specs.

•t12V DC custom distribution panel with digital meters

•t110V AC custom power distribution panels with digital meters & polarity indicator

•t110V 30amp. shore power with 50’ cord

•t110V outlets in galley, head, fwd. cabin & engine room with ground fault protection

•tAGM engine starting battery

•t(2) 200 amp hour AGM house batteries

•t(2) Explosion proof master battery selection switches

•tInverter/battery charger

•tFront opening 12V refrigerator

•tSeparate top access 12V freezer

•tTwo burner ceramic cooktop

•tMicrowave oven

•tChrome overhead lights in galley, dinette, head & V berth

•tChrome swivel reading lights in V berth

•tEngine room lighting

•tHalon extinguishing system in engine room

•t(3) windshield wipers/washers with independent on/off switches at helm

•tRunning lights & anchor light

•tCourtesy lights in cockpit, saloon and interior

•tLight at compass

•tFire extinguishers in cabin & cockpit

Interior

•tMain bulkheads and faces laminate covered marine plywood fiberglassed to hull & deck

•tSatin varnished interior wood trim

•tCabin & locker doors solid wood framed

•tVarnished teak & holly cabin sole

•tRemovable overhead panels in satin white

•tAll exposed interior fiberglass in locker interiors covered with ply, cedar or gelcoat

•tSpacious forward cabin with v-berth or optional island double berth with overhead “aircraft” lockers, bureau with drawers and hanging locker

•tHead with large separate shower

•tCorian countertops in galley & head with under mounted sinks

•tDouble sink at galley with drawers for utensils. Sliding door storage outboard of galley. Tilt out trash bin under sink, dish storage locker above Galley is open to pilothouse for greater light and ventilation

•tAll latches, hinges, catches & pulls are chromed bronze or brass

•tMirror in head

•tTowel rack and cup holder

•t5” foam upholstered cushions in helm area & 6” foam in V berth

Deck

•tAll deck hardware & fittings 316 stainless steel

•tBow fitting with anchor roller

•tWindlass w/SS anchor and 250’ chain/rope

•t(6) stainless steel 10” mooring cleats

•t(4) custom inline toe rail chocks

•t1¼” stainless steel bow rail extending aft to cockpit

•tLarge molded hull rub rail at chine aft with stainless steel half round

•tSolid teak caprail on bulwarks extending aft to cockpit

•tStainless steel striker on hull at sheer to protect teak caprail

•t(2) stainless steel handrails on hardtop

•t(2) stainless steel handrails on cabin top

•t(4) stainless steel opening ports w/screens

•tLarge windows in pilothouse with sliding vents port and starboard

•tLarge sliding doors to aft cockpit from enclosed pilothouse

•tTeak cabin nosing

•t(4) Lewmar aluminium anodized hatches with Oceanair screens and shades

•tMolded fiberglass 6’ 6” settees port and starboard in pilothouse with hinged storage access

•tPedestal mount helmsman and co-pilot seats forward

•tChart table and co-pilot seat

•tDrop leaf dining table to port

•tOverhead handrails in pilothouse

•tHatches in pilothouse floor for engine access

•tHatches in cockpit sole for storage and access

•t4” foam upholstered cockpit cushions

•t(4) fenders and dock lines

Talk to usContactOur Team